Toast Flex - Regulatory Compliance; FCC Regulations and RF Exposure; EU and IC Radio Regulations

19
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment o and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet or a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
To comply with RF exposure requirements, a minimum separation distance of 20cm must be maintained
between the user’s body and the POS machine, including the antenna. Caution: Changes or modifications
not expressly approved by the party responsible for compliance could void the user’s authority to operate
the equipment.
FCC ID: 2AMNG-TT200, 2AB7X-CHB25, 2AB7X-CHB26
FCC Regulations
This device complies with the applicable industry Canada License exempt radio apparatus, the operation is
authorized under the conditions as follows: (1) this device may not cause interference, and (2) the user of
this device must accept any interference caused, even if the interference is likely to aect its performance.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de li-
cence. L’exploitation est autorisée aux deux conditions suivantes : (1) I’appareil ne doit pas produire de brouil-
lage, et (2) I’utilisateur de I’appareil doit accepter tout brouillage radioélectriquie subi, même si le brouillage
est susceptible d’en compromettre le fonctionnement. This device may not cause interference. This device
must accept any interference, including interference that may cause undesired operation of the device.
IC: 23177-TT200
IC Regulations
The manufacturer hereby declares that this device is in compliance with the essential
requirements and other relevant provisions of Radio Equipment Directive 2014/53/
EU. The description of accessories and components, including software, which allow
the radio equipment to operate as intended, can be obtained in the full text of the EU
declaration of conformity at the following internet address: https://pos.toasttab.com.
The Oicial Journal of the European Union Commission Decision of 12 February 2007
states that in the frequency band 5.150 to 5.350 GHz, wireless access systems (WAS),
including radio local area networks (RLANs), shall be restricted to indoor use.
EU Regulatory Conformance
Observe the national local regulations in the location where the device is to be used.
This device may be restricted for use in some or all member states of the European
Union (EU). Adapter shall be installed near the equipment and shall be easily accessible.
The device complies with RF specifications when the device is used 20cm from your
body. The product can be used across EU member states.
Notice
BE BG CZ DK DE EE IE EL ES FR
HR IT CY LV LT LU HU MT NT AT
PL PT RO SI SK FI SE UK
Max, radio-frequency
power transmitted
BT 2402-2480 MHz: 6 dBm
BLE 2402-2480 MHz: 5 dBm
2.4G WIFI 2412-2472 MHz: 15 dBm
5G WIFI 5150-5250 MHz: 12 dBm
5G WIFI 5725-5850 MHz: 12 dBm