How does ignition timing affect abnormally high engine speed in TOHATSU M 60C Outboard Motor?
If your TOHATSU Outboard Motor has an abnormally high engine speed, it could be due to an incorrect adjustment of ignition timing. Consider adjusting it.
Why is the running speed of my TOHATSU M 60C unstable, or why does it stop?
An unstable engine running speed or engine stopping in your TOHATSU Outboard Motor can be caused by several factors: * Insufficient cooling water flow. * A faulty thermostat. * Propeller cavitation. * Incorrect propeller selection. * A damaged or bent propeller. * Unbalanced load in the boat. * Transom being too high or too low. * Incorrect adjustment of the throttle link or ignition timing. * Insufficient battery capacity, loose terminals, or corrosion. * A faulty ignition switch or Power Trim & Tilt switch. * Remote Control lever not set to Neutral. * Safety switch lock plate not fitted. * Incorrect wiring, disconnected, or broken wire. * Starter motor failure. * Air in the power trim & tilt unit.
What to do if remaining oil is less than 3 liters in TOHATSU Outboard Motor?
If the remaining oil is less than 3 liters, refill the engine oil to the appropriate level.
What to do if remaining oil is less than 1.5 liters in TOHATSU Outboard Motor?
If the remaining oil is less than 1.5 liters, refill the engine oil to the appropriate level.
What to do if Power Trim & Tilt is inoperative in TOHATSU Outboard Motor?
If the Power Trim & Tilt is inoperative on your TOHATSU Outboard Motor, it could be due to a faulty ignition switch or Power Trim & Tilt switch. Check these switches.
Why Power Trim & Tilt is inoperative in TOHATSU Outboard Motor if there is air in power trim & tilt unit?
If the Power Trim & Tilt is inoperative on your TOHATSU Outboard Motor, it could be due to air in the power trim & tilt unit.
Why my TOHATSU M 60C Outboard Motor engine starts but stops soon after starting?
If your TOHATSU Outboard Motor starts but stops soon, consider the possibility of using improper engine oil and replace it with the recommended type.
What if recirculation pipe is broken in TOHATSU M 60C that starts but stops soon?
If your TOHATSU Outboard Motor starts but stops soon, a broken recirculation pipe could be the cause. Inspect the recirculation pipe and replace if broken.
What causes abnormally high engine speed in a TOHATSU Outboard Motor?
If your TOHATSU Outboard Motor has an abnormally high engine speed, it could be due to an incorrect adjustment of the throttle link. Consider adjusting it.
Why is my TOHATSU M 60C engine speed unstable or why does it stop?
If your TOHATSU Outboard Motor has an unstable engine running speed or stops, a faulty thermostat could be the cause. Consider checking and replacing the thermostat.
General| Output | 60 HP |
|---|---|
| Starting | Electric |
| Gear Ratio | 2.08:1 |
| Fuel Type | Gasoline |
| Gear Shift | Forward, Neutral, Reverse |
| Alternator Output | 12V |
| Shaft Length | 20 in |
| Control Type | Remote Control |
To Next Page
