To Next PageTo Next PageWhy my TOHATSU Outboard Motor cannot obtain high engine speeds?
If your TOHATSU Outboard Motor cannot reach high engine speeds, consider that it might be due to propeller cavitation. Also, check if the propeller is damaged or bent and replace it if needed.
What to do if remaining oil is less than 1.5 liters in TOHATSU Outboard Motor?
If the remaining oil is less than 1.5 liters, refill the engine oil to the appropriate level.
What to do if remaining oil is less than 3 liters in TOHATSU Outboard Motor?
If the remaining oil is less than 3 liters, refill the engine oil to the appropriate level.
Why is the running speed of my TOHATSU M 60C unstable, or why does it stop?
An unstable engine running speed or engine stopping in your TOHATSU Outboard Motor can be caused by several factors: * Insufficient cooling water flow. * A faulty thermostat. * Propeller cavitation. * Incorrect propeller selection. * A damaged or bent propeller. * Unbalanced load in the boat. * Transom being too high or too low. * Incorrect adjustment of the throttle link or ignition timing. * Insufficient battery capacity, loose terminals, or corrosion. * A faulty ignition switch or Power Trim & Tilt switch. * Remote Control lever not set to Neutral. * Safety switch lock plate not fitted. * Incorrect wiring, disconnected, or broken wire. * Starter motor failure. * Air in the power trim & tilt unit.
General| Output | 60 HP |
|---|---|
| Starting | Electric |
| Gear Ratio | 2.08:1 |
| Fuel Type | Gasoline |
| Gear Shift | Forward, Neutral, Reverse |
| Alternator Output | 12V |
| Shaft Length | 20 in |
| Control Type | Remote Control |
