ENGINE OPERATION 35
7
ENOW00057-0
Do not tilt up outboard motor while engine
operates, or no cooling water may be fed,
leading to engine seizure due to overheating.
ENON00921-0
Note
Before tilting the outboard motor up, after
stopping the motor leave it in the running
position for about a minute to allow water
to drain from inside the engine.
ENOM00222-A
Tilt up
1. Close the fuel cock and tighten the air
vent screw of the tank cap.
2. Fully tilt up the outboard motor.
3. Press in the tilt stopper.
4. Gently lower the outboard motor to
rest on the tilt stopper.
1. Fuel cock
2. Air vent screw
1. Tilt stopper
ENOM01304-0
Outboard motor position in tilt up
When the outboard motor is in the tiltup
position, the tilt handle side must be in
the upward direction. Tighten the steer-
ing friction adjustment screw to keep
the direction.
1. Tilt handle
2. Starter handle
CAUTION
2
1
ENOF02030-A
1
ENOF02031-0
CORRECT
1
2
ENOF02032-1
To Next Page
