INSPECTION AND MAINTENANCE44
10
ENOM01306-0
It is important to inspect and maintain your outboard motor regularly. At each interval
on the chart below, be sure to perform the indicated servicing.
Maintenance intervals should be determined according to the number of hours or num-
ber of months, whichever comes first.
*1: Have this handled by your dealer.
ENON00030-0
Note
Your outboard motor should receive careful, and complete inspection at 300 hours. This is the
best time for major maintenance procedures to be carried out.
2. Periodic Inspection
Item
Servicing Interval
Action Remarks
10 hours
or
1 month
50 hours
or
3 months
Every 100
hours or
6 months
Fuel System
Carburetor *1 z Clean, and adjust.
Fuel filter zzzCheck and clean or Replace.
Piping/Hose z Check and Replace.
Fuel tank zzzClean.
Ignition Spark plugs zzz
Check gaps. Remove carbon
deposits or Replace.
0.9–1.0 mm
(0.035–0.039 in)
Starting
System
Starter rope zzzCheck for wear or chafting.
Lower Unit
Propeller zzz
Check for bent blades, damage,
wear.
Shear pin &
Split pin
zzzCheck and Replace.
Gear oil zzz
Replace or Fill gear oil and check
for water leaks.
180 mL (6.1 fl.oz.)
: 3.5B2
90ml (3.0 fl.oz.) :
2.5A2/3.5A2
Water pump *1
z Check for wear or damage.
Bolt and Nuts zzzRetighten.
Sliding and Rotating Parts.
Grease Nipples
zzApply and pump in grease.
Outer Equipment zzzCheck for corrosion.
Anode zz
Check for corrosion and
deformation.
To Next Page
