14
6.2 SPECIAL OPERATION
6.2.1 Setting of BLIND mode
a) RESET mode
↓ Hold down RESET key for 10 seconds.
a) RESET mode
All LED display fade out in a moment.
↓ Press ▲
▲▲
▲ key, ▼
▼▼
▼ key and MODE key in turn.
j) BLIND mode
Press ▲
▲▲
▲ key and ▼
▼▼
▼ key simultaneously for 3 seconds.
k)Pattern no.
BLIND mode
PTTN/STEP key
e)Pattern No. Setting mode
RESET key
Press MODE and Press MODE key for
▲
▲▲
▲ key for 3 sec. 3 seconds
simultaneously
l)COMMON PARAMETER m)PATTERN PER PARAMETER n)CONTROL CONSTANT setting o)AUTO-TUNING start
BLIND mode BLIND mode BLIND mode BLIND mode
↓Press MODE key ↓Press MODE key ↓Press MODE key ↓Press MODE key
・ ・ ・ ・
・ ・ ・ ・
・ ・ ・ ・
Indication at Setting Value means Display exist, and means no Display.
For canceling BLIND mode, turn the Power OFF once and turn ON the Power again.
6.2.2 Alteration of Parameter per Pattern Setting while operation.
b)RUN mode e)Pattern No. Setting mode
Press MODE key for 10 seconds.
↓Press MODE key
g)Parameter per Pattern setting mode.
Press RUN/STOP key
↓Press MODE key
Press RUN/STOP key
↓Press MODE key
・
・
Press RUN/STOP key
BLIND mode cannot be applied to a)RESET mode, b)RUN mode,
c)SUSPENSION mode and d)PATTERN STEP CONFIRMATION mode.
＊＊＊
＊＊＊
Alteration of each setting
value can be changed even
while program operation,
but not setting value of step.
To Next Page
Loading...
Need help?
General