Tone Commander 6210 - Configuration Troubleshooting

68 Tone Commander 6210/6220 User Manual
Telephone Configuration Troubleshooting
CA/DN trouble Check Fix
Inbound calls to a
specific line cause the
LED to flash, but there is
no audible ringing.
>SETUP >USER
>RING >CONTROL
>Select line
>ALWAYS
A specific line is
selected that is
supposed to have dial
tone, but there isn’t any.
>SETUP >INSTL
>KEYS
>Select line key
>CA/DN
General usage Check Fix
All inbound calls appear
on CA1. Outbound calls
cannot be made.
>SETUP >INSTL
>MORE >MODE
>CACH
Ringing calls are not
answered when going
off-hook.
>SETUP >USER
>MORE >PREF
>RING
Using a specific
headset, the voice level
to other parties is not
loud enough.
>SETUP >USER
>MORE >VOICE
>HEAD >VOLUME
>XMT+ as many
times as required
“SELECT AN IDLE
LINE” is displayed when
going off-hook or
pressing the speaker
key.
Originating DN and
Call Appearance
Reservation settings
See page 32.