Tone TOUCH 03 - 4.4 EDIT RECIPES

14
LAN-Switch / LAN-router
▪ connect the TONE to the LAN switch
▪ connect the LAN switch to the tablet / pc
(direct or via LAN-2-USB converter)
▪ you can connect one or more TONE to the
tablet / pc
NOTE:
The ethernet port configuration on your
tablet / pc should be as follow:
1. connect the cable direct to your device or
via the LAN-2-USB converter
2. Open the ethernet properties
Settings - Network and Internet - Ethernet
- properties
3. Select automatic mode (dhcp) at the ip-
assignment
OPTION 2A
Wifi-Router
▪ connect the TONE to the wifi router
▪ connect the tablet / pc to the wifi router
▪ you can connect one or more TONE to the
tablet / pc
OPTION 2B
Ethernet-2-Wifi-Converter (IO-GEAR)
For each TONE you need an Ethernet-2-
Wifi-Converter
▪ Consider the specific manual / video for
the set-up on www.tone-swiss.com
4.4 EDIT RECIPES
Connect your TONE Touch03 brewer with
the TONE tablet computer as described in
the previous section. Once the installation
is complete, switch your TONE Touch 03
ON and it will appear in the list of available
TONE equipment as soon you select the
tab Touch 03. The factory pre-set name will
be ToneTouch03_XXXXX (XXXXX=serial
number). This can be customised later (s.
Service tab).
Click on your device in the list and the
standard configuration of the recipe
EDIT RECIPES