33
Guitar Synth parameters
Oscillator selection: 0: Sawtooth wave 2 octaves down 1: Sawtooth wave 1 octave down
0...15 (GAIN knob) 2: Sine wave 1 octave down 3: Sawtooth wave
4: Sine wave 5: Sawtooth wave 1 octave up
6: Sine wave 1 octave up 7: Sine wave 2 octaves up
Oscillators 8...15 are oscillators 0...7 with portamento turned on.
VCF setting: 0...10.0 Voltage Controlled Filter sensitivity adjustment
(TREBLE knob) 0...4.7 is sensitivity adjustment in the positive (+) direction,and 5.0...10.0
is sensitivity adjustment in the negative (-) direction.
Set this to 5.0 for a sine wave oscillator.
Direct level: 0...10.0 Adjusts the volume of the guitar.
(BASS knob)
Synth level: 0...10.0 Adjusts the volume of the synth.
(VOLUME knob)
Threshold adjustment: Adjusts the sensitivity of the synth in response to the volume of the guitar
1.0...10.0 (Value dial) Adjust this as appropriate for your guitar or pickup.
The Guitar Synth is effective only when single notes are played. The desired effect will not be obtained
if chords are played.
If your instrument is not tuned correctly, the results may not be as you expect. In this case, re-tune your
instrument.
To Next Page
Loading...