Ⅶ Lubrication system
7.1Lubrication System
1.Must refuel according to requirements of Figure7and Table 6 before start the
machine
2.Lubrication for the worm gear box: use the 30th oil to bath the box; the oil inside
the box is about 1 kg. Oil is plug into the Worm boxes from the top hole. Oil is on the
side of the box, when sawing beams at the lowest position; the Oil surface should
between the superscript. Change the oil a month after for the fist time use, after that,
changes oil each 3-6 months. There is a oil bolts in the lower worm gear box. The
bottom of Machine Box fixed with hydraulic oil and coolant oil Cypriots.
Lubrication point diagram
7.2Saw band lubrication site form
To Next Page
Loading...