9) When welding is complete, set the MIG Gun down on a heat-proof, electrically
nonconductive surface.
10) A weld from flux-cored wire will be covered by slag. Use a chipping hammer to
knock this off. Be careful not to damage the weld or base material.
11) Turn the Power Switch OFF after fan stops rotating. Allow Welder to cool down,
then unplug the Power Cord.
12) Remove Ground Clamp from workpiece or table.
13) Respool wire by clipping wire, removing gas nozzle/contact tip on MIG gun,
releasi
ng Idler Arm on Wire Feed mechanism, and rotating the Wire Spool
c
ounterclockwise. Be sure to securely hold wire as it is being respooled because the
end of wire has a tendency to quickly unravel once it clears the wire feeder.
14) Clean the machine and then store the unit indoors out of children’s reach.
MAINTENANCE AND SERVICE
Procedures not specifically explained in this manual must be performed only
by a qualified technician.
To prevent serious injury from accidental operation:
Turn the Power Switch of the Machine to its “OFF” position and unplug the machine
from its electrical outlet before performing any inspection, maintenance, or cleaning
procedures.
To prevent serious injury from machine failure
Do not use damaged equipment. If abnormal noise or vibration occurs, have the
problem corrected before further use.
1 Cleaning, Maintenance, and Lubrication
1) BEFORE EACH USE, inspect the general condition of the Machine. Check for
loose screws, cracked or broken parts, damaged electrical wiring, and any other
condition that may affect its safe operation.
2) After Use, clean external surfaces of the machine with clean cloth.
3
) Periodically, using compressed air, blow out all dust and debris from the interior.
4) If the unit repeatedly shuts down from thermal overload, stop all use.
Have the Machine inspected and repaired by a qualified service technician.
5) Store the Machine and accessories in a clean and dry location out of reach of
children.
WARNING! If any part of this Machine is damaged, it must be replaced only
by a qualified service technician.
A Parts list and assembly diagram are provided as following just for
reference. Contact the distributer or the seller to get the spare parts for
maintenance and have the damaged parts be replaced by a qualified
technician only.
7
To Next Page
Loading...