22
rigging the spinnaker kit (...)
The spinnaker sheet ratchet blocks are simply attached to
the lower part of the shroud plates.
end of the pole so you do not lose it up the mast.
The free end is threaded through the pulley at the back of
the pole (from back to front).
The line then threads through the double block attached to
the tack line (this pulls the sail to the end of the pole).
9
10
11
The halyard is then lead back through the cleat on the cross
beam, to the ring by the rear beam and forward to the metal
the line under the jib sheets).
12
To Next Page
Loading...
