Topcon ES-103 - Bluetooth Communication Procedures

10. CONNECTING TO EXTERNAL DEVICES
44

When "Wireless" is set to "Yes" in "Comms setup" in Config mode []/
[] is displayed in OBS mode.
• Softkeys (in OBS mode)
• Audio tones
(While connecting/disconnecting)
Start paging/waiting: short beep
Connection successfully established: long beep
Connection canceled/being canceled: two short beeps
Paging failed/waiting time out: two short beeps
(While inquiring about other Bluetooth devices)
New device discovered: short beep
Inquiry complete: long beep
• After a certain period of time has passed since Bluetooth communication is
interrupted, the ES's Bluetooth function is automatically turned OFF.
PROCEDURE Bluetooth communication as "Slave"
1. Complete the necessary settings
for Bluetooth communication.
 "10.1 Necessary settings for
Bluetooth communication
PROCEDURE Set Bluetooth
communication mode to
"Slave""
Softkey Connection mode Operation
[]
Slave Enter waiting status
Master Establish a connection
[]
Slave Cancel the connection/exit waiting status
Master Cancel a connection/stop establishing a
connection