WARNING:
DO NOT TEST THROUGH THE JUMPSTART POSTS. For models that hold
the battery under the seat or in the trunk, the manufacturer usually includes
jumpstart connector conductor posts under the hood (See Figure 3.3.2) to make
jumpstarting easier. However, to ensure data accuracy and operation safety, DO NOT
CONNECT THE BATTERY TESTER TO THE JUMPSTART POSTS.
Figure 3.3.2
Figure 3.4.1
1) Before connecting the clamps to the terminals, please use sandpaper to polish
off any corrosion on the battery terminals. With this, you can avoid inaccurate test
values.
2) Attach the red clamp to the positive (+) terminal and the black clamp to the
negative (-) (See Figure 3.4.1).
• ALWAYS KEEP THE RED & BLACK CLAMPS FROM TOUCHING.
• ALWAYS DISCONNECT THE NEGATIVE CABLE FROM THE BATTERY FIRST AND
RECONNECT IT LAST.
3) Once the clamps are properly connected, the battery tester will power on
automatically and be ready to conduct tests.
3.4 Connect the Clamps to the Battery Terminals.
EN I 10
To Next Page
