TOPP K140 - Installing the Casing

3.9
INSTALLING THE CASING
21
INSTRUCTIONS FOR INSTALLATION AND USE
antivibration
felt
M3,5x9,5 screws for
fastening casing
A
Fig.
32
Fasten the lateral caps on the beam using 3 screws type TSP d3.5x9.5 for each cap, supplied in the hardware package.
Apply an antivibration felt strip every 300mm along the beam (Fig.32 Ref.1).
Fit the upper part of the casing in its housing on top of the beam, holding it in a tilted position at a 30° angle and insert it until
it is flush (Fig.32 Ref.2).
Fasten the casing to the beam using two more screws type TSP d3.5x9.5 (Fig.32 Ref.3).
If it should not be possible to fasten the casing from the side, proceed as follows:
% Drill symmetrical holes in the casing cover using a suitable drill with a Ø6.5 bit for aluminum, with the measurements
and position indicated in Fig.32 Ref.4
% Fasten the casing to the beam using the two screws type TCEI M5x10.
4
12mm
Ø6.5
1
2
3
M5x10 screws for
fastening casing
EN
K140
Rating place and “CE” marking