IT
EC DECLARATION OF INCORPORATION OF PARTLY COMPLETED MACHINERY
7
53
EN
K140
INSTRUCTIONS FOR INSTALLATION AND USE
The undersigned, in the name of and behalf of the following company
Topp S.r.l.
Via Galvani, 59
36066 Sandrigo (VI)
Italia
herewith declares
that the person authorised to compile the technical file is
Name: Bettiati Roberto - Topp S.r.l.
Address: via Galvani,59 36066 Sandrigo (VI)
and
that to the partly completed machinery
ELECTROMECHANICAL AUTOMATION FOR LINEAR SLIDING
DOORS WITH ONE OR TWO LEAFS
Type: K140
Serial number and year of construction: from no.1603TB01112 to no. 16120PF1999
the following essential requirements of the following EC directive
(including all applicable amendments)
2006/42/EC Machinery Directive (Italian adoption DLgs 27 jan. 2010, n.17)
have been applied and fulfilled:
Enclosure I:1.1.2 a)-b)-c)-e), 1.1.3, 1.1.5, 1.2.1, 1.2.3, 1.2.5, 1.2.6, 1.3.1, 1.3.2,
1.3.3, 1.3.4, 1.3.7, 1.5.1, 1.5.2, 1.5.4, 1.5.5, 1.5.6, 1.5.8, 1.5.10, 1.5.11, 1.5.13,
1.6.1, 1.6.2, 1.6.3, 1.7.4;
and that the relevant technical documentation is compiled in accordance with part B of Annex
VII of the above mentioned Machinery Directive.
The above identified partly completed machinery is also in conformity with the all the relevant
provisions of the following EC directives (including all applicable amendments)
2014/30/EU EMC Directive
2011/65/EU ROHS II Directive
2014/53/EU R&TTE Directive
The following harmonised standards have been applied:
EN 16005 EN 61000-6-2 EN 61000-6-3
EN 50581 EN 62233
EN 60335-1 Applicable parts of EN 60335-2-103
The undersigned also undertakes the obligation, in response to a duly reasoned request by the
national market surveillance authorities, to transmit to the a.m. authorities, in electronic or
paper format, the relevant technical documentation on the partly completed machinery.
The above identified partly completed machinery must not be put into service until the final
machinery into which it is to be incorporated has been declared in conformity with the
provisions of the above mentioned Machinery Directive.
This declaration of conformity is issued under the sole responsibility of the manufacturer.
Date: Sandrigo, 01/03/2016 Signature: Matteo Cavalcante
Administrator ............................................................
ORIGINAL
To Next Page
Loading...