TROUBLESHOOTING
PROBLEM CAUSE-SOLUTION
Sporadic Tool Action: • Air in the hydraulic system. Bleed the hydraulic circuit.
• Check reservoir oil level.
Motor Will Not Start: • Be sure power cord is not damaged.
• Check for tripped circuit breaker; be sure breaker is of
adequate size.
• Have motor checked for proper operation.
• Have qualied electrician inspect for loose or faulty wiring or
switch.
.
Noisy Operation: • Air in system.
• Be sure the oil reservoir is lled to normal level.
• Check all points where air might leak into system.
• Clogged or blocked intake screen.
Pump Oil is Over Heating: • Inspect for high pressure leakage at the pump (leaking at
plug or relief valve).
• Oil level is low. Fill reservoir to normal level, or retrot the
pump with larger reservoir or heat exchanger.
Pump Runs But Will Not Pump Oil: • Pump is not primed. Run pump a few minutes tipping from
side to side.
• Inspect to make sure that external adjustable relief valve is
set properly.
• Defective control valve, take to nearest TorcUP Authorized
Service Center for repair.
• Incorrect motor rotation, take to nearest TorcUP Authorized
Service Center for repair.
• Check to make sure the intake screen is not clogged. Clean
if needed.
• Check oil reservoir is low. Fill as needed.
• Oil viscosity is too high. Replace with TorcUP oil.
To Next Page
Loading...
