TorcUP TX-32 User Manual (English)

Other manuals for TorcUP TX-32

Operation And Maintenance Manual42 pages

Questions and Answers:

K
Kristine SmithAug 5, 2025
Why is my TorcUP Power Tool pump not building up pressure?
- B
  Becky GreenAug 5, 2025
  If your TorcUP Power Tool pump isn't building up pressure, several factors could be at play. Begin by checking the relief valve for any defects, and consider adjusting or replacing it if necessary. Ensure that your air supply and hose size meet the recommendations outlined in the pump manual. For electric pumps, verify that the amperage, voltage, and extension cord size are compliant with the pump manual's requirements. Replace the gauge if it is defective. Also, check the oil level and replenish the pump reservoir if it's low. Lastly, inspect the pump filter for clogs; clean or replace it as needed.
V
Vanessa ColemanAug 9, 2025
What to do if my TorcUP Power Tool tightens immediately when turned on?
- R
  Robert SmithAug 9, 2025
  If your TorcUP Power Tool tightens immediately upon activation, the hose connections are likely reversed. To correct this, depress the advance button to release the tool, then switch off the pump while it's in the advance position. Finally, reverse the hose connections.
R
Roberto PowersAug 13, 2025
How to fix a TorcUP TX-32 Power Tool when the piston will not advance or retract?
- X
  xelliottAug 13, 2025
  If the piston of your TorcUP Power Tool isn't advancing or retracting, start by checking the coupler connections to ensure they are securely attached to both the tool and the pump. Replace any couplers that are defective. If the issue persists, the remote control switch may be faulty, requiring replacement of the switch or control pendant. Another potential cause is dirt in the direction-control valve of the pump unit, which would necessitate disassembling the pump and cleaning the valve.
A
Ashley WrightAug 17, 2025
What to do if the cylinder of my TorcUP TX-32 will not build up pressure?
- S
  Sharon BrightAug 17, 2025
  If your TorcUP Power Tool's cylinder isn't building up pressure, it could be due to several reasons. Start by checking the piston seal and end plug seal for leaks, and replace any defective o-rings. Also, inspect the retaining screws for shearing and replace any that are broken. Finally, a defective coupler could also be the cause, so replace any that are faulty.