Battery
Installation
Paper Loading Instructions
1. Open the cover and prepare to load paper on hubs.
2. Free paper from roll, and position roll so paper drapes from
underneath
the back of the roll.
3. Feed paper over top roller and between top and bottom roller.
4.
Manually
turn top roller to engage paper between rollers.
5. Close cover. Dispenser will feed first sheet. Dispenser is ready for use.
Preventive
Maintenance
The dispenser should be cleaned any time there is heavy paper dust build-up inside the dispenser. If
paper dust is not a problem,
approximately
every year is a good
frequency
for cleanings. The following is
the
recommended
procedure to cleaning:
1) Open the dispenser and remove the roll of paper. Clear all paper from the feed assembly.
2) Clean out any paper dust. This can be done is several ways, such as, vacuuming, blowing out with a
can of
compressed
air (wear safety glasses), wiping out with a damp cloth, etc.
3) Clean the cover with a general all-purpose cleaner that is safe for plastics.
To Next Page
Loading...
