PROGRAMMING INSTRUCTIONS
EW101B
EW103B
ONE YEAR LIMITED WARRANTY: If this product
fails because of a manufacturing defect within
one year after purchase, we will, at our option,
either repair or replace it at no charge. Our
warranty does not cover damage caused by
accident, abuse or misuse. We assume no
further liability with respect to the sale or use
of this product. THIS WARRANTY IS IN LIEU
OF ALL OTHER WARRANTIES, EXPRESSED OR
IMPLIED, INCLUDING THE WARRANTY OF
MERCHANTABILITY. We make no warranty with
respect to the fitness of any goods for the users
particular application. This warranty gives you
specific legal rights, and you also may have
other rights which vary from state to state.
It is our intent to provide accurate and current
specification information. However, in the
interest of product improvement, TORK may
alter the specifications or constructional details
without prior notice.
LI-882(C)
FOR TECHNICAL SUPPORT: SOUTIEN TECHNIQUE : PARA COMUNICARSE CON EL SERVICIO TÉCNICO: techsupport@nsiindustries.com 888.500.4598
OVR
EW120B
EW201B
When powering up the unit for the first time, allow 1-2 minutes to charge
the supercap. The unit is ready when "12:00 AM" flashing is displayed on
screen. Press reset button after 2 minutes if screen is blank.
1.0 PRESS MODE TO GO TO THE CLK MODE.
2.0 TO SET CLOCK
3.0 TO SET DATE
4.0 AUTOMATIC DAYLIGHT SAVING TIME ADJUSTMENT
5.0 SETTING AN ON TIME
5.1 SETTING AN OFF TIME
5.2 NEXT SCHEDULE
Repeat steps 5.0 & 5.1 for additional ON/OFF pairs OR
6.0 AUTO (AUTOMATIC) MODE
NOTE: AUTO mode will follow the programmed schedule. OVR sets ON/OFF
until the next event.
7.0 MAN (MANUAL) MODE
NOTE: MAN mode will bypass programmed schedule. OVR set ON/OFF until
next OVERRIDE push.
NOTE: Press RESET with an insulated tool to clear time and date. To clear all,
press ENTER, press EVENT, then press ENTER again.
MODE
MODE
To Next Page
Need help?
General
