Testing of the garage door operator
Check list for the garage door operator
Conrm features at start-up with a check mark.
No. Equipment present Features to be tested Remarks
1.0 Garage door
1.1 Manual operation of the door Smooth running
1.2 Fastenings/connections State/Seat
1.3 Pivots/joints State/Lubrication
1.4 Track rollers/track roller holders State/Lubrication
1.5 Seals/sliding contact strips State/Seat
1.6 Door frame/door guide Alignment/Fastening
1.7 Door leaf Alignment/State
2.0 Weight counterbalance/safe opening
2.1 Springs State/Seat/Setting
2.1.1 Spring strips State
2.1.2 Spring break device State/Data plate
2.1.3 Safety elements (spring connector,…) State/Seat
2.2 Wire cables State/Seat
2.2.1 Mounting State/Seat
2.2.2 Cable drum 2 Safety windings
2.3 Fall protection State
2.4 Concentricity of T-shaft State
3.0 Operator/controls
3.1 Operator/sliding rail/bracket State/Fastening
3.2 Electrical cables/connections State
3.3 Emergency release Function/State
3.4 Control devices, push-button/hand transmitter Function/State
3.5 Limit stop State/Position
4.0 Safeguarding of crush and shearing zones
4.1 Force limit Stops and reverses
4.2 Protection against lifting of persons Door leaf stops at 20 kg
4.3 Site conditions Safely distances
5.0 Other devices
5.1 Latching/lock Function/State
5.2 Wicket Function/State
5.2.1 Wicket door contact Function/State
5.2.2 Door closer Function/State
5.3 Trafc light control Function/State
5.4 Photoelectric sensors Function/State
5.5 Closing edge safety device Function/State
6.0 Documentation of the operator/owner
6.1 Data plate/CE marking complete/readable
6.2 Door system’s declaration of conformity complete/readable
6.3 Installation, Operation and Maintenance Instructions complete/readable
To Next Page
Loading...
