18
MAINTENANCE
SCHEDULE FOR SERVICE
MAINTENANCE DAILY WEEKLY MONTHLY
EVERY SIX
MONTHS 100 HOURS 200 HOURS
Clean squeegee assembly. Check blades for wear or
damage. Check if adjustment needed to squeegee
height
X
Clean out recovery tank inside and out and oat shut
o assembly. Check both for damage. Leave recovery
tank open during storage
X
Clean pad / brush and check for wear or chemical
build up
X
Check handles, knobs and switches for damage
X
Charge batteries (if machine used longer than 30
minutes)
X
Check hoses for wear, blockages or damage
X
Clean outside of solution tank and clean inline
solution lter. Check both for damage
X
Check wet battery water level and add distilled water
if necessary
X
Check splash guard around scrub head for damage
(disk models only)
X
Thoroughly clean entire machine
X
Check linkages and connectors for wear / damage
X
Check all bearings and wheels for noise or loose
hardware
X
Check recovery tank lid gasket for wear or damage
X
Check batteries for cracks, corrosion or signs of
overheating
X
Check belt for excessive wear (S-24XM only)
X
Check all screws and nuts. Tighten if necessary
X
Inspect isolators (orbital units only)
X
Check for loose wires or connections
X
Clean batteries and terminals
X
Blow out dust in motors
X
Clean pivot points on squeegee and scrub deck
linkages
X
NOTE: With regular maintenance, the lifetime of your machine and its safe operation are extended and ensured. Scheduled
maintenance should be performed by qualied personnel or by an authorized service center.
WARNING:
These maintenance procedures must be performed with the machine o and the batteries disconnected.
Make sure to read all safety instructions prior to performing maintenance.
To Next Page
Loading...
Need help?
General