[4]: Use dry rag to clean the dust on air vent of the inverter and the motor for preventing fault from dust blocking in the
next application.
[5]: Check whether the whole machine and the accessories are in good condition, and make necessary repair and
maintenance before storage.
[6]: Keep the machine in the clean and dry place, and when storing, place the handset in the vertical position and fasten
tightly.
3.3 Instructions for using Floor Grinding Machine
[1]: In flattening the base plane, mount the diamond tool on the machine and grind in “double-cross” shape until being
flat.
[2]: Clean the ground dust and fix up loopholes.
[3]: Paint oil painting or adhesion agent onto it according to the floor type and technique requirement.
3.4 Equipment Dismounting Steps and Precaution
3.4.1 Carrying Steps
[1]: Firstly, pull up the power plug lightly.
[2]: If dismounts after dry grinding, please first to disconnect the vacuum cleaner; if dismounts after wet grinding, please
first to wipe out the redundant water in the water tank.
[3]: As shown in Figure 17, insert and lock the lifting bar into the socket.
[4]: As shown in Figure 17, one person lifts the lifting bar at ①, and one person lifts the handle at ②. Two persons
cooperate well to make strength at the same time to lift up the machine frame lightly, and place it appropriately.
Figure 17
3.4.2 Notes for Carrying
[1]: Before carrying the machine, make sure the power switch is in off state, and there’s no redundant water in the water
To Next Page
Loading...
General