Toro 03678 - Installing the CE Hood Latch; Using the Cutting-Unit Kickstand

1.Removethe3bolts,washers,andspacerssecuringthetractionmanifoldtothebottomoftherear
bumper(Figure16a).
2.Positiontheappropriateamountofweightonthetopand/orbottomoftherearbumper.
3.Mounttheweight(s)andthetractionmanifoldtothebumperwiththe3bolts,washersandspacers
previouslyremoved(Figure16b).
Note:Donotusethespacerswheninstallingmorethantwoweightsunderthebumper(Figure16c).
4.Securetheouteredgesoftheweight(s)tothebumperwith2carriageboltsandnuts(Figure16c).
6
InstallingtheCEHood
Latch
Partsneededforthisprocedure:
1Hoodlatchassembly
1Washer
Procedure
1.Unlatchandraisethehood.
2.Removetherubbergrommetfromtheholein
theleftsideofthehood(Figure17).
g004143
Figure17
1.Rubbergrommet
3.Removethenutfromthehood-latchassembly
(Figure18).
g003946
Figure18
1.Hoodlatch3.Rubberwasher
2.Nut4.Metalwasher
4.Outsidethehood,insertthehookendofthe
latchthroughtheholeinthehood.
Note:Makesurethattherubbersealingwasher
remainstotheoutersideofthehood.
5.Insidethehood,insertthemetalwasheronto
thelatchandsecurewiththenut.
Note:Makesurethatthelatchengagesthe
framecatchwhenitislocked.Usetheenclosed
hoodlatchkeytooperatethehoodlatch.
7
UsingtheCutting-Unit
Kickstand
Partsneededforthisprocedure:
1
Cutting-unitkickstand
Procedure
Wheneveryoumusttipthecuttingunittoexposethe
bedknife/reel,propuptherearofthecuttingunitwith
thekickstandtoensurethatthenutsonthebackend
ofthebedbaradjustingscrewsarenotrestingonthe
worksurface(Figure19).
15