Toro 07413LT - Page 36

g192345
Figure41
1.Cotterpin
3.Dustcap
2.Nutretainer
9.Installthecotterpinandbendeachlegsaround
theretainer(Figure41).
10.Installthedustcapontothehub(Figure41).
11.Repeatsteps1through10forthehubandrotor
attheothersideofthemachine.
InstallingtheBrakesandWheels
1.Cleanthe2ange-headbolts(3/8x3/4inch)and
applyacoatofmedium-strengththread-locking
compoundtothethreadsofthebolts.
2.Alignthebrakepadstoeithersideoftherotor
(Figure36)andtheholesinthecaliperbracket
withtheholesinthebrakemountofthespindle
frame(Figure40).
3.Securethecaliperbrackettothespindleframe
(Figure36)usingthe2ange-headbolts(3/8
x3/4inch).
Torquethe2ange-headboltsto47to54N∙m
(35to40ft-lb).
4.Aligntheholesinthewheeltothestudsofthe
hubandassemblethewheeltothehubwiththe
valvestemoutward(Figure35).
Note:Ensurethatthemountingsurfaceofthe
wheelisushwiththehub.
5.Securethewheeltothehubusingthelugnuts
(Figure35).
Torquethelugnutsto108to122N∙m(80to90
ft-lb).
6.Repeatsteps1through5forthebrakeand
wheelontheothersideofthemachine.
36