10
Installing the Wheels
Note: Install the rear wheels to the machine while it is still
on the pallet shipping blocks.
1. Mount a wheel to each wheel motor and secure them
with the lug nuts. Tighten the lugs nuts evenly and
gradually in a crisscross manner to 45–55 ft.-lb.
(61–75 N⋅m).
2. Remove the shipping blocks and lower the machine
onto the rear wheels.
1
Figure 1
1. Rear wheel
Note: We suggest saving the shipping blocks, as they are
the correct height for blocking the unit when changing the
tires, servicing the wheel motors, or performing other
service work.
Installing the Steering Wheel
1. Move the front wheel so that it points straight ahead.
2. Slide the steering wheel onto the steering shaft, aligning
the mounting holes.
3. Secure the steering wheel in place with the roll pin
(Fig. 2).
1
2
Figure 2
1. Steering wheel 2. Roll pin
Removing The Battery
1. Pivot seat upward and engage seat prop.
2. Remove (2) wing nuts and washers securing top
battery hold down to side battery hold downs
(Fig. 3). Remove top battery hold and remove
battery.
4
3
1
2
Figure 3
1. Battery
2. Positive (+) battery
terminal
3. Negative (–) battery
terminal
4. Top battery hold down
To Next Page
Loading...
