Figure 9
1. Cargo box 3. Cargo box mounting hole
2. Pivot bracket
4. Inser t the right hand pi v ot brac k et into the
mounting hole in the carg o bo x and then
mount it to the frame .
5. Ha v e another person help to raise the carg o
bo x.
6. Loosen the bolt securing the prop rod clip to
the frame until y ou can slide the J-hook end of
the prop rod under the clip ( Figure 10 ).
Figure 10
1. Prop rod
3. Bolt (5/16 x 3/4 inch)
2. Prop rod clip
4. Flange nut (5/16 inch)
7. Tighten the bolt and secure the other side of
the clip with a new bolt (5/16 x 3/4 inc h) and
flang e n ut (5/16 inc h) ( Figure 10 ).
8. Lo w er the carg o bo x.
Step
7
Activating the Battery
No Parts Required
Procedure
None
Note: T his procedure is only needed for Model
No . 07277TC .
If the batter y is not filled with electrolyte or
acti v ated, it m ust be remo v ed from the v ehicle ,
filled with electrolyte , and c harg ed. Bulk electrolyte
with 1.260 specific g ra vity m ust be purc hased from
a local batter y supply outlet.
1. R emo v e the batter y hold-do wn and lift the
batter y out of the batter y base .
Batter y electr ol yte contains sulfuric acid
which is a deadl y poison and causes
sev er e bur ns.
• Do not drink electr ol yte or allo w it to
contact y our skin, ey es or clothing .
W ear safety g lasses to shield y our
ey es and r ub ber g lo v es to pr otect y our
hands.
• Fill the batter y wher e clean w ater is
al w ays a v aila ble f or flushing the skin.
2. R emo v e the filler caps from the batter y and
slo wly fill eac h cell until electrolyte is just abo v e
the plates .
3. R e place the filler caps and connect a 3 to
4 amp . batter y c harg er to the batter y posts .
Charg e the batter y at a rate of 3 to 4 amperes
for 4 to 8 hours (12 v olts). Do not o v erc harg e
the batter y .
14
To Next Page
Loading...
