Toro 12004TC Twister 1600 - Electrical System Maintenance; Replacing Fuses and Headlights

3. R emo v e the clamps securing the fuel filter to
the fuel lines ( Figure 37 ), as follo ws:
A. Squeeze the clamp tabs tog ether and slide
the clamps up the hose off of the filter
hose fittings .
B . Pull the hose ends off of the filter hose
fittings .
Figure 37
1. Fuel lter
4. Install the re placement filter to the fuel lines
with the clamps previously remo v ed.
Mount the filter so that the ar ro w points
to w ard the carburetor .
Electrical System
Maintenance
Replacing the Fuses
T here are 3 fuses in the electrical system. T hey are
located beneath the bed in a bo x on the right hand
side of the frame ( Figure 38 ).
Charge circuit
25 amp.
Lights
10 amp.
Power Point
10 amp. (15 amp. max.)
Low oil light and hour
meter
10 amp.
Figure 38
1. Charge circuit
3. Power point
2. Lights 4. Low oil light and hour
meter
Replacing the Headlights
Specification: GE #862
1. Set the parking brak e , tur n the ignition off , and
remo v e the k ey .
2. Switc h the headlights off .
3. R eac h beneath the dash and rotate the
lamp assembly 1/4 tur n countercloc kwise
( Figure 39 ).
Figure 39
1. Lamp assembly 3. Tabs
2. Reector 4. Slots
4. Pull the lamp assembly out of the reflector .
5. R emo v e the lamp assembly from the wire
har ness .
6. Discard the lamp assembly .
7. Push the re placement lamp assembly onto the
wire har ness .
8. R eac h beneath the dash and align the three
tabs on the lamp assembly with the slots in the
reflector ( Figure 39 ).
9. Inser t the lamp assembly into the reflector and
rotate it 1/4 tur n cloc kwise until it stops .
32