Assembling the Assist
Handle
1. Assemble the grooved pin through the hole in
the assist handle as shown in Figure 1 .
g464941
Figure 1
1. Assist handle 3. Retaining ring
2. W asher (3/8 inch) 4. Pin (grooved)
2. Secure the pin to the handle with the washer
(3/8 inch) and the retaining ring ( Figure 1 ).
Installing the Assist-Handle
Bracket
Measuring and Drilling Holes into
the Frame Rail
1. Hold the assist-handle bracket against the
left frame rail and position it according to the
measurement for your particular model ( Figure
2 ).
g464996
Figure 2
A: T imeCutter models. B: T itan models.
1. Assist-handle bracket
3. 1 13 mm (4-7/16 inches)
2. Left frame rail 4. 146 mm (5-3/4 inches)
2. Using the assist-handle bracket as a template,
draw marks through the holes onto the frame
rail ( Figure 3 ).
2
To Next Page
Loading...
