Toro 161-4450 - Securing the Bracket to the Frame Rail; Installing the Assist Handle to Bracket

g465023
Figure 3
1. Mark and drill holes here.
2. Left frame rail
3. Drill holes at the marked locations using a drill
bit (9/32 inch) as shown in Figure 3 .
W ARNING
Using a drill without proper eye
protection may allow debris to enter the
eye, causing injury .
When drilling, always wear eye
protection.
Securing the Bracket to the Frame
Rail
Secure the bracket to the side of the left frame rail
using 2 thread-forming hex ange-head bolts.
g465027
Figure 4
1. Hex ange-head bolt (thread-forming—5/16 x 3/4 inch)
Installing the Assist Handle
1. Align the lower hole in the assist handle with
the closed slot in the assist-handle bracket as
shown in Figure 5 .
g465144
Figure 5
T imeCutter model shown
1. W asher (3/8 inch) 3. Pin (grooved)
2. Retaining ring
2. Assemble the grooved pin through the slot in
the bracket and the hole in the assist handle
( Figure 5 ).
3. Secure the pin to the bracket and handle with
the washer (3/8 inch) and the retaining ring
( Figure 5 ).
3