EasyManua.ls Logo

Toro 20041 - Component Maintenance and Replacement; Air Filter and Engine Oil Replacement

Toro 20041
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
3352-568 Rev A
Replacing the Air Filter
Replace the air filter yearly; replace it more frequently
in dusty operating conditions.
Refer to Preparing for Maintenance on page 11.
1. Use a screw
driver to open the
air filter cover.
m-7314
2. Replace the air
filter.
m-7315
3. Install the cover.
Changing the Engine Oil
Change the engine oil after the first 5 operating
hours; change it yearly thereafter.
Run the engine a few minutes before changing the oil
to warm it. Warm oil flows better and carries more
contaminants.
Refer to Preparing for Maintenance on page 11.
1. Remove the
dipstick.
m-7310
2. Tip the mower
onto its left side to
drain the used oil
out through the oil
fill tube.
m-7316
3. Slowly pour oil into
the oil fill tube until the
oil level reaches the Full
line on the dipstick. Do
not overfill. (Max. fill:
20 oz., type: SAE 30W
detergent oil with an API
service classification of
SF, SG, SH, SJ, SL, or
higher.)
m-7310
4. Install the dipstick securely.
5. Dispose of the used oil properly at a local
recycling center.

Related product manuals