Toro 20041 - Engine Operation; Starting and Stopping the Engine; Self-propel Drive Operation

8
3352-568 Rev A
Operation
Starting the Engine
1. Firmly push in
the primer 3 times
with your thumb,
holding the primer
in for a second
before releasing it
each time.
Note: If the air
temperature is
below 55
°
F (13
°
C),
firmly push the
primer in 5 times.
m-7311
2. Hold the blade
control bar (A)
against the handle.
A
m-5578
3. Start the engine using either the ignition key or
the recoil starter.
or
m-5606
m-5592a
4. If the mower does not start in 1 or 2 pulls (or
within 5 seconds using the electric starter), press the
primer button 1 or 2 times and try starting it again.
Note: If the mower still does not start, contact an
Authorized Service Dealer.
Using the Self-propel Drive
To operate the self-propel drive, simply walk with your
hands on the upper handle and your elbows at your
sides, and the mower will automatically keep pace
with you.
m-5582
m-5613
Stopping the Engine
To stop the engine, release the blade control bar.
Remove the ignition key when you leave the mower.
Important: When you release the blade control bar,
both the engine and blade should stop within
3 seconds. If they do not stop properly, stop using
your mower immediately and contact an Authorized
Service Dealer.
m-5582