6-22 WPM Drive Systems Manual
BBC / BOS / BCS
TORO RECYCLER/REAR BAGGER
BBC
Idler Arm System Disassembly (Recycler/
Rear Bagger)
Fig 183 1350-001 a
1. Drain the fuel and oil. Remove the spark plug wire.
Disassembly for the idler arm begins on top of the
mower housing.
Fig 185 3428-0177-2
3. Take a loop of wire or rope and unhook the spring
under the lever (Fig. 185). With the tension removed
you can now remove the long screw through the
lever. We would suggest loosening this screw, but
leave it engaged at this time (Fig. 187).
Fig 184 3428-0174
2. On the left side of the mower next to the rear wheel,
loosen the clamp that secures the BBC cable to the
mower housing. Near the left front wheel, unhook
the spring end of the cable from the bellcrank.
Remove the screw, bellcrank, sleeve, and unhook
the control link from the lever (Fig. 184).
A. Spring C. Wire loop
B. Screwdriver
A
B
C
To Next Page
Loading...
