6-27WPM Drive Systems Manual
BBC Cable Removal (Recycler/Rear Bagger)
Fig 199 3428-0192
9. Start the shaft into the hole in the housing. Rotate
the idler/brake arm clockwise so the upper tab on
the spring can engage the boss in the housing.
Rotate the idler/spring arm counterclockwise (Fig.
199) and push the rest of the way into the housing.
The brake pad should now ride on the brake drum.
Fig 198 3428-0190
8. Slip the spring over the shaft. One tang of the spring
must engage the tab as shown (Fig. 198).
BBC / BOS / BCS
10. Hold the idler/brake arm in place. Slip the spring
over the end on top of the deck as shown. Install
the lever and install the screw through the lever and
idler/brake arm shaft (Fig. 200). Once the screw is
secured take a loop of wire or rope and hook the end
of the spring. Pull it towards you and hook the end
as shown.
Fig 200 3428-0177-3
1. Loosen the cable clamp and pull cable out from
under the screw (Fig. 201).
Fig 201 3428-0172
A. Idler/brake arm
A. Spring C. Wire loop
B. Screwdriver
A
B
C
To Next Page
Loading...
