7-19WPM Drive Systems Manual
HANDLES AND CONTROL CABLES
Lawn-Boy Insight Platimun:
1. Remove the gas and oil and tip the mower on its
side with the air fi lter up.
2. Remove the BCS cover and belt cover.
3. Loosen the 2 cap-screws securing the bracket to
the housing. Pull the cable to the rear to remove
the slack. Push the cable forward 5/8” (1.5cm) and
secure. This will create 5/8” (1.5cm) of slack (Fig.
272).
Fig 272 DSC-5352a
4. Install the BCS cover, belt cover and tunnel.
To Next Page
Loading...
