2-6 WPM Drive Systems Manual
SINGLE SPEED SPUR/BEVEL GEAR TRANSMISSION
Prior to installation of oil impregnated bushings, it is
wise to apply a light coating of engine oil to the running
surface (Fig. 037). Add grease and install the cover.
Fig 037 3428-0019
Finally, install the spacer and pulley on the input shaft.
The internal gears will help hold the pinion while the nut
is tightened (Fig. 038).
Fig 038 3428-0022
Insert the transmission back into the chassis. Refer
to the section on the wheel pinion clutch for assembly
instructions.
Install self propel cable. Adjust as needed; see “Handles
and Control Cables” Section 7.
To Next Page
Loading...
