3-11WPM Drive Systems Manual
SINGLE SPEED BEVEL GEAR TRANSMISSION
3. Remove the plug from the hole next to where the
self propel cable goes through the chassis (Fig.
062).
Fig 062 MVC-735
4. Tip the mower on its side. The cable snaps in from
the top and connects to an arm on the transmission
belt guide (Fig. 063).
Fig 063 PICT-1884a
Fig 064 PICT-1895a
5. The cable tool (P/N 105-6819) will compress the
locking tabs on the cable so it can be removed from
the housing.
6. Slide the cable tool over the end of the cable and
push (Fig. 064). At the same time, reach around the
mower and pull the cable out of the housing.
Fig 065 PICT-1904
7. With the plug removed from the larger hole next to
the cable, move the cable through the slot (Fig. 065).
A. Cable B. Belt guide
A
B
A
A. Cable tool
To Next Page
Loading...
