3-13WPM Drive Systems Manual
14. Place the mower right side up and remove the three
hex head and one Allen head cap screws on each
side that hold the height of cut plates to the chassis
(Fig. 070). The transmission assembly will now drop
down.
Fig 070 MVC-848
Fig 072 MVC-743
16. The belt cover must be removed in order to remove
the belt (Fig. 072).
Fig 071 MVC-852
15. There is a cross brace underneath the mower that is
held in place by two of the cap screws shown above
(Fig. 071).
SINGLE SPEED BEVEL GEAR TRANSMISSION
17. Remove 3 screws that secure the belt cover to the
housing (Fig. 073).
Fig 073 MVC-744
A
A. Belt cover
To Next Page
Loading...
