5-10 WPM Drive Systems Manual
WHEEL PINION CLUTCH
Fig 144 MVC-850
4. Slide the wheel pinion off the axle.
Note: There is a spring-loaded key under the pinion
(Fig. 144).
5. Behind the pinion should be another thrust washer
and retaining ring (Fig. 000). (MVC-850)
A. Retaining ring and B. Key
thrust washer
A
B
2. Lubricate with anti-seize and assemble in the
original order.
Reassemble in reverse order:
1. Install one thrust washer, then the fi rst retaining ring
with the sharp edge facing the chassis (Fig. 145).
Fig 145 MVC-472
To Next Page
Loading...
