To Next PageTo Next Page
Need help?Do you have a question about the Toro 20373 and is the answer not in the manual?
Locate and replace safety and instruction decals near areas of potential danger.
Install the blade-control bar into the upper handle as shown in the figure.
Move the handle to the operating position and tighten the handle knobs securely.
Ensure the engine has the correct oil level before starting the machine; it ships without oil.
Check the engine-oil level before each use or daily to prevent engine damage.
Adjust the cutting height by setting the front and rear wheel levers to the desired height.
Follow the ignition switch and recoil starter instructions to start the engine properly.
Push the ignition switch to the Stop position to safely stop the engine.
Procedure for changing the engine oil after initial use and annually thereafter.
Instructions for annually replacing or sharpening the mower blade for optimal cutting.
Prepare the machine for storage by adding fuel stabilizer and running the engine dry.
Locate and replace safety and instruction decals near areas of potential danger.
Install the blade-control bar into the upper handle as shown in the figure.
Move the handle to the operating position and tighten the handle knobs securely.
Ensure the engine has the correct oil level before starting the machine; it ships without oil.
Check the engine-oil level before each use or daily to prevent engine damage.
Adjust the cutting height by setting the front and rear wheel levers to the desired height.
Follow the ignition switch and recoil starter instructions to start the engine properly.
Push the ignition switch to the Stop position to safely stop the engine.
Procedure for changing the engine oil after initial use and annually thereafter.
Instructions for annually replacing or sharpening the mower blade for optimal cutting.
Prepare the machine for storage by adding fuel stabilizer and running the engine dry.
General| Engine | Briggs & Stratton |
|---|---|
| Cutting Height | 1.25 to 3.75 inches |
| Deck Material | Steel |
| Mulching Capability | Yes |
| Power Source | Gasoline |
| Start Type | Recoil |
| Starter Type | Recoil |
| Bagging Capability | Yes |
| Side Discharge Capability | Yes |
| Fuel Tank Capacity | 0.25 gallons |
| Cutting Width | 22 inches |
