Toro 20373 - Checking the Engine-Oil Level; Adjusting the Cutting Height

G017304
Figure11
CheckingtheEngine-OilLevel
ServiceInterval:Beforeeachuseordaily
1.Movethemachinetoalevelsurface.
2.Removethedipstick(Figure12).
G017323
Figure12
1.Theoillevelisatits
maximum.
3.Theoillevelistoo
low—addoiltothe
crankcase.
2.Theoillevelistoo
high—removeoilfrom
thecrankcase.
3.Wipethedipstickcleanwithacleancloth.
4.Insertthedipstickintotheoil-lltubebutdonot
screwitin,thenremovethedipstick.
5.Readtheoillevelonthedipstick(Figure12).
•Iftheoillevelonthedipstickistoolow,slowly
pourasmallamountofoilintotheoil-lltube,
wait3minutes,andrepeatsteps3through5until
theoillevelonthedipstickisatthecorrectlevel.
•Iftheoillevelonthedipstickistoohigh,drainthe
excessoiluntiltheoillevelonthedipstickisat
thecorrectlevel.RefertoChangingtheEngine
Oil(page17).
Important:Iftheoillevelinthecrankcaseistoo
lowortoohighandyouruntheengine,youmay
damagetheengine.
6.Installthedipsticksecurely.
AdjustingtheCuttingHeight
WARNING
Adjustingthecuttingheightmaybringyouinto
contactwiththemovingblade,causingserious
injury.
•Stoptheengineandwaitforallmovingparts
tostop.
•Donotputyourngersunderthehousingwhen
adjustingthecuttingheight.
CAUTION
Iftheenginehasbeenrunning,themuferwillbe
hotandcanseverelyburnyou.Keepawayfromthe
hotmufer.
Adjustthecuttingheightasdesired.Setthefrontwheelsto
thesameheightastherearwheels(Figure13).
Note:Toraisethemachine,movethefrontcuttingheight
leversrearwardandtherearcuttingheightleversforward.
Tolowerthemachine,movethefrontcuttingheightlevers
forwardandtherearcuttingheightleversrearward.
10