Toro 20373 - Starting the Engine; Using the Self-Propel Drive

g027908
Figure13
1.Raisethemachine2.Lowerthemachine
Note:Thecuttingheightsettingsare25mm(1inch);35mm
(1-3/8inches);44mm(1-3/4inches);54mm(2-1/8inches);
64mm(2-1/2inches);73mm(2-7/8inches);83mm(3-1/4
inches);92mm(3-5/8inches);and102mm(4inches).
StartingtheEngine
1.Iftheignitionswitchonyourmachine(Figure14)isa
toggleswitch(withbothan“I”anda“Stop”),pushthe
switchtothe(“I”)position.Otherwise,gotostep2.
G017317
Figure14
1.Ignitiontoggleswitch
2.Pulltherecoilstarterlightlyuntilyoufeelresistance,
thenpullitsharply(Figure15).Allowtheropeto
returntothehandleslowly.
Figure15
Note:Ifthemachinedoesnotstartafterseveral
attempts,contactanAuthorizedServiceDealer.
UsingtheSelf-PropelDrive
Tooperatetheself-propeldrive,simplywalkwithyourhands
ontheupperhandleandyourelbowsatyoursides,andthe
machinewillautomaticallykeeppacewithyou(Figure16).
Figure16
Note:Ifthemachinedoesnotfreelyrollbackwardafter
self-propelling,stopwalking,holdyourhandsinplace,and
allowthemachinetorollacoupleofinches/centimeters
forwardtodisengagethewheeldrive.Youcanalso
tryreachingjustunderthepersonalpacehandletothe
metalhandleandpushthemachineforwardacouple
ofinches/centimeters.Ifthemachinestilldoesnotroll
backwardeasily,contactanAuthorizedServiceDealer.
11