Toro 30411 - Hydraulic Control Manifold Service: Cutting Deck Lift;Lower

Groundsmaster 4100--D Hydraulic SystemPage 4 -- 75
Hydraulic Control Manifold Service: Cutting Deck Lift/Lower
1. Manifold body
2. Pilot valve
3. Seal kit
4. Relief valve (Counterbalance)
5. Seal kit
6. Plug (SAE #2)
7. O--ring
Figure 59
2
6
7
1
2
3
5
4
3
35 to 40 ft--lb
(47to54N--m)
35 to 40 ft--lb
(47to54N--m)
35 to 40 ft--lb
(47to54N--m)
41 to 49 in--lb
(4.6 to 5.6 N--m)
NOTE: The ports on the manifold are marked for easy
identification of components. Example: C1 is the con-
nection port from the LH wing deck lift cylinder and CHG
is the charge circuit connection (See Hydraulic Sche-
matic to identify the function of the hydraulic lines and
cartridge valves at each port).
For cartridge valve service procedures, see Hydraulic
Control Manifold Service: 4 Wheel Drive in this section.
Refer to Figure 59 for cartridge valve and plug installa-
tion torque.
Hydraulic
System