Toro 30411 - Fuses

Groundsmaster 4100−D Page 5 − 11 Electrical System
Fuses
The fuse blocks are located under the operator’s control
console.
Identification, Function, and Wiring
The fuses are held in two fuse blocks. Use Figure 11 to
identify each individual fuse and its correct amperage.
Each fuse holder has the following functions and wires
connected to it.
Fuse A1 (5 amp)
A. Supplies power to the seat switch.
B. Has green wire and red wire (battery).
Fuse A2 (10 amp)
A. Supplies power to ignition switch terminal B.
B. Has pink wire and red wire (battery).
Fuse A3 (10 amp)
A. Supplies power to the PTO switch.
B. Has yellow wire and red wire (battery).
Fuse A4 (10 amp)
A. Supplies power to the starter solenoid.
B. Has orange wire and red wire (battery).
Fuse B1 (10 amp)
A. Supplies power to the power point outlet.
B. Has white wire and red wire (battery).
Fuse B4 (when optional lighting is installed)
A. Supplies power for optional light kit.
B. Has two red wires.
Figure 11
10A
5A
10A
10A
10A
A
B
1234
1234
OPT.
Figure 12
PTO
10A
STARTER
SOLENOID
POWER
10A
OUTLET
LIGHT
KIT
IMPLEMENT
5A
IGNITION
10A
SWITCH
THERMAL
25A
BREAKER
SEAT
5A
SWITCH
10A
20A
Electrical
System