Toro 30411 - Chapter 8; Cutting Deck; Wing Deck Service

Rev. C
Groundsmaster 4100−DCutting Deck
Page 8 − 10
Wing Deck Service
1. Wing deck (RH shown)
2. Flex shield
3. Cap screw
4. Switch actuator
5. Lock nut
6. Thrust washer (.030” thick)
7. Link assembly
8. Flat washer
9. Flange nut
10. Screw (6 used per flex shield)
11. Lock nut
12. Anti−scalp roller
13. Cap screw
14. Flange nut
15. Flange screw (2 used per skid)
16. Skid (RH shown)
17. Flange bushing
18. Grease fitting
19. Latch
20. Flat washer
21. Cap screw (3 used per latch)
22. Lock nut (3 used per latch)
23. Bushing (3 used per latch)
24. Spring support
25. Compression spring
26. Lug nut
27. Lock roller (2 used per latch)
28. Flange nut
29. Pivot pin
30. Center deck
31. Cap screw
32. Hex jam nut
33. Shield strap (wing deck)
34. Shield strap (center deck)
35. Cap screw
36. Washer
37. Retaining ring
38. Latch pin
39. Carriage bolt
40. Switch shield (RH shown)
41. Washer head screw
42. Hardened spacer (.120” thick)
Figure 6
FRONT
RIGHT
1
2
7
10
11
14
15
9
12
13
16
31
32
33
34
6
7
17
21
18
22
19
23
20
24
26
27
17
25
23
160 to 180 ft−lb
(217 to 244 N−m)
29
28
35
36
18
30
6
3
4
5
8
37
38
39
40
41
37
42
42
Removal (Fig. 6)
1. Position machine on a clean, level surface. Lower
cutting deck and engage parking brake.
2. Fully raise wing deck, stop engine, and remove key
from the ignition switch. Remove three (3) washer head
screws and shield strap that secure flex shield to wing
deck. Lower wing deck.
3. Remove hydraulic motor from wing deck (see Cut-
ting Deck Motor Removal in the Service and Repairs
Section of Chapter 4 − Hydraulic Systems).
4. Remove cap screw and lock nut that secure lift cylin-
der clevis to the wing deck (Fig. 7).
5. Remove switch shield from center deck.