Groundsmaster 4100--D Hydraulic SystemPage 4 -- 95
Removal
1. Park machine on a level surface, lower cutting
decks, stop engine, engage parking brake, and remove
key from the ignition switch.
2. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
3. To prevent contamination of hydraulic system during
steering valve removal, thoroughly clean exterior of
steering valve and fittings.
4. Remove steering valve from machine using Figure
75 as a guide.
Installation
1. Install steering valve using Figure 75 as a guide.
2. Make sure hydraulic tank is full. Add correct oil if nec-
essary before returning machine to s ervice (see Opera-
tor’s Manual).
Hydraulic
System
To Next Page
Loading...
