Toro 30411 - Page 241

Rev. C
Groundsmaster 4100−D Cutting DeckPage 8 − 15
Installation (Fig. 12)
1. Position spindle on cutting deck noting orientation of
grease fitting (Fig. 14). Secure spindle assembly to deck
with correct fasteners.
2. Install cutting blade, anti−scalp cup, and blade bolt
(see Operator’s Manual). Tighten blade bolt from 88 to
108 ft−lb (119 to 146 N−m).
3. Slowly rotate cutting blades to verify that blades do
not contact any deck component(s).
4. Install drive belt and adjust belt tension (see Opera-
tor’s Manual).
5. If drive spindle was removed, install hydraulic motor
to cutting deck (see Cutting Deck Motor Installation in
the Service and Repairs Section of Chapter 4 − Hydrau-
lic Systems).
6. Install belt covers to cutting deck (see Operator’s
Manual).
1. Flange head screw 2. Hydraulic motor
Figure 13
1
2
1
1. Driven spindle
2. Drive belt
3. Drive spindle (wing deck)
4. Drive spindle (center deck)
5. Idler pulley
6. Driven spindle (high pulley)
7. Spindle grease fitting location
Figure 14
5
7
6
3
7
2
5
1
7
2
7
1
5
4
3
5
7
2
2
1
7
Cutting Deck