Toro 30446 - Cutting Deck Lift Switches

Groundsmaster 4000--D/4010--D Page 5 -- 25 Electrical System
Cutting Deck Lift Switches
The cutting deck lift switches are used as inputs for the
TEC--5001controller toraise orlowerthecuttingdecks.
Whenthe frontof alift switchisdepressedandheld,the
controlleddeckswill lower. When therearofa lift switch
is depressed and held, the controlled decks will raise.
The decks will remain in position when the switch is re-
leased.The lift switches arelocated on theconsolearm
(Fig. 25).
NOTE: To lower the cutting decks, traction speed has
to be in low range (4WD). Also, to raise or lower the
decks, the operator seat has to be occupied.
Testing
1. Before disconnecting the lift switch for testing, the
switch and its circuit wiring should be tested as a
TEC--5001 input with the Diagnostic Display (see Diag-
nostic Display in the Troubleshooting section of this
chapter). If the Diagnostic Display verifies that the lift
switchandcircuitwiringarefunctioningcorrectly,nofur-
therswitchtestingisnecessary.If,however,theDisplay
determines that the lift s witch and circuit wiring are not
functioning correctly, proceed with test.
2. Make sure ignition switch is OFF. Remove key from
ignition switch.
3. Disassemble console arm to gain access to cutting
deck liftswitches (see Console Arm Disassembly in the
Service and Repairs section of Chapter 7 -- Chassis).
4. Disconnectharness electrical connector from the lift
switch that is to be tested.
5. Theswitchterminalsaremarkedas shown inFigure
26. The circuit logic of the lift switches is shown in the
chartbelow.Withtheuseofamultimeter(ohmssetting),
theswitchfunctionsmaybetestedtodeterminewhether
continuityexists betweenthe variousterminalsforeach
position.Verifycontinuitybetweenswitchterminals.Re-
place lift switch if testing identifies a faulty switch.
SWITCH
POSITION
CLOSED
CIRCUITS
OPEN
CIRCUITS
DECK LOWER 2+3
5+6
2+1
5+4
NEUTRAL NONE ALL
DECK RAISE 2+1
5+4
2+3
5+6
6. Ifliftswitchtestscorrectlyandcircuitproblemstillex-
ists,checkwireharness(seeElectricalSchematicsand
Wire Harness Drawings in Chapter 10 -- Foldout Draw-
ings).
7. After testing is completed, connect wire harness
connector to the lift switch.
8. Assembleconsolearm(see ConsoleArmAssembly
inthe Serviceand Repairssectionof Chapter7 -- Chas-
sis).
1. Console arm
2. Front deck lift switch
3. RH deck lift switch
4. LH deck lift switch
Figure 25
1
2
3
4
Figure 26
BACK OF SWITCH
NOTE: Lift switch terminals 4, 5 and 6 are not used on
Groundsmaster 4000--D and 4010--D machines.
Electrical
System