Groundsmaster 4500--D/4700--DPage 5 -- 10Electrical System
Starting Problems
Problem Possible Causes
No electrical power to machine (including gauges). Battery is discharged.
Battery cables are loose or corroded.
Ground connection on machine is loose or c orroded.
The ignition switch or circuit w iring is faulty.
Starter solenoid clicks, but starter will not crank.
NOTE: Ifthesolenoidclicks,theproblemisnotinthein-
terlock circuit.
Battery is discharged.
Battery cables are loose or corroded.
Ground connection on machine is loose or c orroded.
Wiring at the starter is faulty.
Starter solenoid is faulty.
Starter is faulty.
Nothing happens when start attempt is made. Control
panel lights and gauges operate with the ignition
switch in ON.
The traction pedal is not in neutral position.
Operator seat is unoccupied OR the parking brake is
not applied.
The PTO switch is ON (engaged).
Fuse F1--1 (20 amp) is faulty (open).
TEC--5002 fuses are faulty.
The traction neutral switch or circuit wiring is faulty.
Seat switch or circuit wiring is faulty.
Ignition switch or circuit wiring is faulty.
Parking brake switch or circuit wiring is faulty.
Start relay or circuit wiring is faulty.
Starter solenoid or starter motor is faulty.
TEC--5002 controller is faulty.
Engine starts, but stops when the ignition switch is
released from the START position.
The engine run s olenoid or circuit wiring is faulty
(solenoid pull coil operates but hold coil is faulty).
To Next Page
Loading...
