Toro 30857 - Page 251

Groundsmaster 4500--D/4700--D Page 7 -- 11 Chassis
Removal (Fig. 10)
1. Park machine on a level surface, lower cutting
decks, stop engine, engage parking brake and remove
key from the ignition switch.
2. Removecuttingdeckfromliftarm (see Cutting Deck
Operator’s Manual).
3. Removeliftcylinderpin(item10)thatsecuresliftcyl-
inder to lift arm.
4. Loosenandremovelocknut(item17)frompivotpin.
5. Supportliftarmand pull liftarmpivotpinfrom lift arm
and frame. Locate and remove thrust washer (item 14)
from rear of lift arm during pivot pin removal.
6. Remove lift arm from machine.
7. Disassemble lift arm as needed using Figure 10 as
a guide.
8. Clean lift arm and pivotpin.Inspectliftarmbushings
andpivotpinfordamageorwear.Replacew ornordam-
aged components.
Installation (Fig. 10)
1. Assemble lift arm using Figure 7 as a guide.
2. Position lift arm to frame ( Fig. 10). Fit thrust washer
(item 14) between rear of lift arm and frame. Slide pivot
pin into frame and lift arm. Align roll pin in pivot pin with
slot in frame flange.
3. Installandtightenlocknut(item17)tosecureliftarm
pivot pin.
4. Secure lift cylinder to lift arm with cylinder pin (item
10). Secure cylinder pin to lift arm with flange head
screw and flange nut.
NOTE: Install thrust washer on deck pivot shaft before
installing cutting deck on pivot shaft.
5. Position and install cutting deck to lift arm (see Cut-
ting Deck Operator’s Manual).
NOTE: The lift arms for cutting decks #2 and #3 are
fittedwithaliftarmrotationstopblock(item3).Thisstop
istokeepthedeckstablewhileraised.Toadjustrotation
stop,removetwo(2)setscrewsfromstopandfullyraise
cutting deck to position the stop. Apply Loctite #242 (or
equivalent) to set screws and install s et screws to se-
cure stop. The rotation stop should contact the lift arm
across the full width of the stop.
6. Lubricate lift arm andliftcylindergreasefittingsafter
assembly is complete.
7. After assembly, raise and lower the cutting deck to
verify that hydraulic hoses and fittings do not contact
anything.
Figure 11
#4 Deck #1 Deck #5 Deck
#7 Deck
(GM4700)
#6 Deck
(GM4700)
#3
Deck
#2
Deck
CUTTING DECK LOCATIONS
Chassis